Follow us

Themes

You are Here: Skip Navigation LinksHome > Help and support > Helpful articles > Netgear DG834G setup

How to set-up my Netgear wireless router

How do I configure my Netgear wireless router?

This guide assumes the Netgear router is already successfully achieving an ADSL signal and is connected to the computer using the provided Ethernet cable.

We advise that you also read our ‘How to secure my wireless connection’ article once you have completed these steps, to ensure you are connecting securely.

Before going any further!

It is often good practice to hard reset the Netgear router before attempting a setup. This is especially the case when you have made several attempts to complete the setup and failed, or you have attempted to use the Netgear setup CD. If the router is 'fresh out the box', a hard reset is not necessary.

Step 1 - Hard reset your Netgear router

  • With the Netgear router powered on, place a small thin implement such as a pen or a pin into the small reset button on the back of the Netgear router.
  • Hold the reset button in for at least 15 seconds and release.

Step 2 - Setup your Netgear router

  • Type http://192.168.0.1 into the Internet Explorer address bar and click ‘Go’.
  • Enter ‘admin’ as the username and ‘password’ as the password. Click OK
  • Click on ‘ADSL settings’ found in the top left-hand corner
  • Set multiplexing Method to LLC-BASED
  • Set VPI to 1 and set VCI to 50. Click ‘Apply’


    • Click to enlarge.

  • Click on ‘Basic Settings’.
  • Scroll down to Login name and remove Guest.
  • Enter your Karoo Username and enter your Karoo Password. Click ‘Apply’


    • Click to enlarge.

  • To check the Netgear router is connected to the ADSL service click ‘Router Status’ and ‘Connection Status’. Close the ‘Connection Status’ box


    • Click to enlarge.